1. The parameters of the new wrapping machine are not set properly. After the wrapping machine is purchased, we must first make certain settings according to the product parameters to be packaged, for example, according to the product to wrap several layers of wrapping film, run up and down several times and other information, which requires customers to follow their own product practice The status can be set, and customers can set it by themselves after purchasing, just open the control panel.
2. The newly purchased wrapping machine will definitely have different problems when using it. If some suppliers have special technicians for on-site training, it will be much better, but the cost of on-site device debugging is relatively high; If there is no on-site installation and debugging, it may be relatively troublesome to set by the customer himself.
3. Can you return to the original interface. There are many parameters for setting on the control panel of the film wrapping machine, but can the user return the interface to the original interface after setting these parameters? If it does not return to the original interface, the machine will default to the set state , it will not stop automatic operation.
4. Whether the stretch film can be fixed on the product. When wrapping the article, the wrapping film has to pass through the formwork, which is known to the customer, but the wrapping film must be fixed on the formwork, and then fixed on the wrapping object, so that when the formwork rises or falls, the wrapping is Only the film can wrap the product normally enough.
