The bubble film machine should assign a special person to operate the equipment. It is not allowed to idle the extruder screw without material, so as to avoid scratches on the screw and the barrel. After shutdown, if there is material stored in the barrel, before restarting the machine, the temperature of each temperature zone must be raised to the specified requirements according to the process requirements, and the temperature must be kept for more than 30 minutes before starting. It is strictly forbidden to start the machine before the temperature reaches the requirements. so as not to damage the parts.
The bubble film machine must be kept clean when feeding into the hopper, and strictly prevent metal debris, sand, gravel and small tools from entering the material port to prevent damage to the barrel and screw. If abnormal noise is found during operation, it should be stopped immediately for processing.
