Bubble bag machine is made of high-quality polyethylene resin, which is also a commonly used packaging material and has a wide range of uses. The middle layer of the foam film is filled with air, light in weight, good in elasticity, and has the properties of sound insulation, shock resistance and wear resistance. This product can replace protective equipment such as foamed plastic particle fillers. Then, let's take a look at the maintenance of the bubble bag machine.
The air bubble bag machine should be inspected regularly, the air cushion should be thoroughly cleaned every three months, the grease of various bearings should be replaced every three months, the reducer should be replaced every six months, and the entire equipment should be overhauled every two years. Check whether the temperature control of the bubble bag machine is normal, whether the heating device is normal, and whether the temperature of each point is within the index range to ensure the normal operation of the machine.
When filling the hopper, it must be clean. Strictly prevent metal garbage, gravel and small tools from entering the material inlet, avoid damage to the oil cylinder and screw, and if abnormal noise is found during operation, it should be stopped in time.
When the screw of the bubble bag machine is taken out of the cylinder for some reason, it must be handled properly to avoid deformation. If it is not installed in the cylinder for a long time, the screw must be suspended vertically to prevent bumps, instability and permanent deformation. Coat the surface of barrel and screw with anti-rust oil for protection.
Check the power supply, vacuum system, air pressure system, and cooling system before starting the bubble bag machine. After the equipment is started, check whether the rotation direction of each rotating part is correct. Usually, pay attention to checking the lubrication condition of each lubricating part. The electrical appliances are normally maintained and maintained according to the regulations.
Bubble film equipment must be assigned a special person to operate, and the extruder screw is not allowed to run idly without material, so as not to damage the screw and barrel. After shutdown, if there is storage in the tank, before starting the machine again, the temperature of each temperature zone should be raised to the specified requirements according to the process requirements, and the temperature should be kept for more than 30 minutes before starting the machine. It is strictly forbidden to turn on the power before the temperature reaches the requirement, so as not to damage the parts.
When the hopper is put into operation, it should be kept clean, strictly prevent metal waste, gravel, small tools, etc. from entering the feeding port, so as to avoid damage to the oil cylinder and screw. If abnormal noise is found during operation, it should be stopped in time.
In addition to daily maintenance, the bubble bag machine should also be inspected regularly, the die should be thoroughly cleaned every three months, the grease of various bearings should be replaced every three months, the grease of the reducer should be replaced every six months, and the entire equipment should be overhauled every two years. . Read the manual carefully before operating the device to understand the control and adjustment functions; be vigilant and pay attention to the safety signs; put on appropriate protective goggles on the bubble bag machine; correctly use maintenance tools with appropriate protective clothing; warm equipment. Pay attention to high temperature melt overflow; pay attention to scratches on precision parts; implement proper maintenance and maintenance of the equipment, and use wires and power supply parameters that meet the requirements.
It is absolutely forbidden to connect the power supply during the circuit inspection; it is strictly forbidden to put the limbs into the parts that may endanger the human body such as the machine transmission; after the equipment inspection, it should be returned to the equipment protection facilities together with the fashion; before connecting the power supply, make sure that the machine is well grounded.
The above is the maintenance of the bubble bag machine. For more information, feel free to contact us! Our company has many years of experience and is looking forward to your joining.
